Panasonic WJ-FS309 User Manual

39

■

• When loss of the camera switching pulse is detected,

“SW LOSS” will blink on the monitor screen.

• The buzzer does not beep.
• When the camera switching pulse is recovered, “SW

LOSS” is cleared from the monitor.

The Video Multiplexer WJ-FS309/FS409 (WJ-FS316/FS416)
can be reset to the initial factory settings as follows.

1. Turn off the Power Switch.

2. Turn on the Power Switch (;) while pressing the 

,

and 

buttons (WJ-FS309/FS409) or 

,

and 

buttons (WJ-FS316/FS416). All LEDs light

up.

3. Resetting is completed when the buzzer stops beeping.

Do not turn off the Power Switch until the buzzer

stops beeping.

MENU

ESC

13

12

MENU

ESC

5

4

■

Channel loss may occur initially after completing the setup
with the WJ-MP204. In this case, press the ALARM RESET
button. Channel loss can be avoided by setting CHANNEL
LOSS to OFF beforehand.

Operating the WJ-FS309/FS409 from the WV-CU360
System Controller

• When operating from the WJ-FS309/FS409, the menu

can be accessed without entering a password even if
PASSWORD is set to ON. Password entry is required
though to operate the Video Multiplexer from the
System Controller.

• To select a monitor from the WV-CU360, press 1 and

MON for Multiscreen output and 2 and MON for Spot
output.

• The ALARM SUSPEND function is not available on the

WJ-FS309/FS409, but can be accessed from the
Controller.