Galil DMC-3425 Manual De Usuario

4.   There is a failure with the output IC that drives the error signal. 

Abort - A low input stops commanded motion instantly without a controlled deceleration.  For any 
axis in which the Off-On-Error function is enabled, the amplifiers will be disabled.  This could cause 
the motor to ‘coast’ to a stop.  If the Off-On-Error function is not enabled, the motor will 
instantaneously stop and servo at the current position.  The Off-On-Error function is further discussed 
in this chapter. 

Forward Limit Switch - Low input inhibits motion in forward direction.  (The CN command can be 
used to change the polarity of the limit switches.)  If the motor is moving in the forward direction when 
the limit switch is activated, the motion will decelerate and stop.  In addition, if the motor is moving in 
the forward direction, the controller will automatically jump to the limit switch subroutine, #LIMSWI 
(if such a routine has been written by the user).   

Reverse Limit Switch - Low input inhibits motion in reverse direction.  (The CN command can be 
used to change the polarity of the limit switches.)  If the motor is moving in the reverse direction when 
the limit switch is activated, the motion will decelerate and stop.  In addition, if the motor is moving in 
the reverse direction, the controller will automatically jump to the limit switch subroutine, #LIMSWI 
(if such a routine has been written by the user).  

The DMC-3425 provides a programmable error limit.  The error limit refers to a difference in the 
actual and commanded position of the motor.  This limit can be set for any number between 1 and 
32767 using the ER n command.  The default value for ER is 16384. 

ER 200,300 

Set A-axis error limit for 200, B-axis error limit to 300 

ER,1 

Set B-axis error limit to 1 count. 

The units of the error limit are quadrature counts.  The error is the difference between the command 
position and actual encoder position.  If the absolute value of the error exceeds the value specified by 
ER, the DMC-3425 will generate signals to warn the host system of the error condition. These signals 
include: 

# POSERR 

Jumps to automatic excess position error subroutine (if included in 
program) 

Error Light 

Turns on 

OE Function 

Shuts motor off if OE1 

AEN Output Line 

Goes low 

The Jump if Condition statement is useful for branching within the program due to an error.  The 
position error of A and B can be monitored during execution using the TE command. 

The DMC-3425 provides programmable forward and reverse position limits.  These are set by the BL 
(Backwards Limit) and FL (Forward Limit) software commands.  Once a position limit is specified, the 
DMC-3425 will not accept position commands beyond the limit. Motion beyond the limit is also 
prevented.