Bacharach INSIGHT Manual De Usuario

14

15

lated data no matter what zoom level has been selected.  Select the desired 

zoom level as follows:

1. Enter the Setup Menu per Section 3.5.1.  If necessary, press ESC 

until MENU appears above F2.

2. From the SETUP MENU, use the ▲▼ 

buttons to select ZOOM.  Press ENTER to 

display the Zoom Menu.

3. Use the ▲▼ buttons to select the desired 

zoom level.

4. Press ENTER to save the selection and dis-

play the SETUP MENU or ESC to revert to 

the previous setting.  

The name of the user or owner (e.g. company name, address, phone num-

ber) can be stored in memory by manually entering up to three lines of 

text, with each line containing up to 20 alphanumeric characters.  This 

information will appear at the top of each printout, until it is cleared or 

new information is entered.

1. Enter the Setup Menu per Section 3.5.1.  If necessary, press ESC 

until MENU appears above F2. 

2. Use the ▲▼ buttons to select USERNAME.  

Press ENTER to display the most recently 

saved information.

3. Use the ▲▼ buttons to select the line of in-

formation which you would like to edit and 

press ENTER.  A single cursor will appear 

denoting the character you are changing.

4.  Use the ▲▼ buttons to scroll the the list of 

alphanumeric characters and the ◄► but-

tons to move across the screen.  

5. Press ENTER to save the selection or ESC to 

revert to the previous input.  

6. Repeat Steps 3-5 to edit the remaining lines.

7.  Once the input is complete, use the ▲▼ buttons to select EDIT 

COMPLETE.

8.  Press ENTER to accept the entered information or ESC to revert to 

the previous information and display the SETUP MENU. 

Helpful Hint: Use the Fyrite

 user software to upload this informa-

tion from your computer.

1. Enter the SETUP MENU per Section 3.5.1.  If necessary, press ESC 

until MENU appears above F2.

2.  Use the ▲▼ buttons to select USERNAME.  Press ENTER to dis-

play the most recently saved information.

3. Clear the information by selecting the CLEAR option (F3).

Fyrite INSIGHT test data is located in the Run/Hold screen.  By press-

ing the RUN/HOLD key, you should hear the pump running and see the 

word RUN at the upper-left hand corner of the display.  The instrument 

is continuously measuring and calculating the data that is shown in the 

Run/Hold screen. Press the RUN/HOLD key again.  The pump should stop 

running and the word HOLD should be shown at the upper-left hand cor-

ner of the display.  The instrument will now show the last measured and 

calculated data taken before the instrument was placed in HOLD.  Use the 

▲▼ buttons to scroll through the complete list of measured and calculated 

values when the instrument is running or in the HOLD mode.

The order in which data appears in the RUN/HOLD screen is as follows:

O

2 

  

=  Oxygen

CO  

=  Carbon 

Monoxide

Eff  

=  Combustion 

Effi ciency

CO

2

  

= 

Carbon 

Dioxide

T-STK  

= 

Stack Temperature

T-AIR   

= 

Ambient/Primary Air Temperature

EA  

=  Excess 

Air

CO(n)   

= 

Carbon Monoxide content referenced to an Oxygen                                     

 

 

 

percentage

NOTE:  (n) is the current O

2

 Reference selected.