Bacharach INSIGHT Manual De Usuario

12

13

Select to display pressure in inches of water column (inwc), millibar (mb), 

Pascals (Pa), hectoPascals (hPa), or millimeter of water column (mmwc) as 

follows:

1. Enter the Setup Menu per Section 3.5.1.  If necessary, press ESC 

until MENU appears above F2.

2. From the SETUP MENU, use the ▲▼ but-

tons to select PRESSURE UNITS.  Press 
ENTER

 to display the Pressure Units Menu.

3. Use the ▲▼ buttons to selecte the desired 

pressure unit.

4. Press ENTER to save selection and return 

to the SETUP Menu or ESC to revert to the 
previous setting.

The clock settings (12 hr. AM/PM or 24 hr.) and date format options (MM/

DD/YY or DD/MM/YY) are interdependent. (See DATE FORMAT, Section 

3.5.15).  

1. Enter the Setup Menu per Section 3.5.1.  If necessary, press ESC 

until MENU appears above F2.

2. From the SETUP MENU, use the▲▼ but-

tons to select CLOCK.  Press ENTER to 

display the Clock Setup Screen

3. Use the ▲▼ buttons to enter the current 

date and time. Use the the ◄► buttons to 

move the cursor across the screen.

4. Press ENTER to save the selection and re-

turn to the SETUP MENU or ESC to revert 

to the previous setting.

The measured value of CO can be referenced to a specific O2 percentage of 

0% to 15%.  Set up the reference value as follows:

1. Enter the Setup Menu per Section 3.5.1.  If 

necessary, press ESC until MENU appears 

above F2.

2. From the SETUP MENU, use the ▲▼ 

buttons to select O2 REFERENCE.  Press 
ENTER

 to display the O2 Reference Screen.

3. Use the ▲▼ buttons to enter the O2 refer-

ence value.

4. Press ENTER to save the selection and re-

turn to the SETUP MENU or ESC to revert 

to the previous setting.

Select whether to print or not print the pressure measurement on the com-

bustion test printout as follows:

1. Enter the Setup Menu per Section 3.5.1.  If necessary, press ESC 

until MENU appears above F2.

2. From the SETUP MENU, use the ▲▼ but-

tons to select PRINT PRESSURE.  Press 
ENTER

 to display the O2 Reference Screen.

3. Use the ▲▼ buttons to select YES or NO to 

print the pressure measurement.

4. Press ENTER to save the selection and re-

turn to the SETUP MENU or ESC to revert 

to the previous setting.

Combustion test data in the Run/Hold screen can be shown with enlarged 

characters to make viewing easier.  The operator can set zoom levels to 

Standard, 2X or 3X.  The Standard zoom setting will display 4 lines of 

combustion test data at one time; 2X will display 3 lines of data with en-

larged characters; 3X will display 2 lines of data with enlarged characters. 

The operator can scroll through the complete list of measured and calcu-