Regency P33-LP3 Manual De Usuario

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace

1)  Open the bottom louvers.

2)  Loosen the thermocouple or thermopile with 

a 7/16" wrench.

3)  Disconnect thermocouple by loosening nut 

from the valve with a 9mm wrench. Dis-
connect thermopile by loosening 2 screws 
marked TP on the valve.

4)  Drop the thermocouple or thermopile down 

from the bracket and pull it out of the unit.

5)  Reinstall the new ones in reverse order.

 
If the glass gasket requires replacement use 
5/8" fl at glass gasket for the Bay Front (Part 
# 936-243) and a tadpole glass gasket for the 
Flush Front (Part # 936-155). 

Your Regency stove is supplied with high 
temperature, 5 mm Neoceram ceramic glass 
that will withstand the highest heat that your 
unit will produce.   If your glass requires clean-
ing, we recommend using an approved glass 
cleaner available at all authorized dealers. Do 
not use abrasive materials. Do not clean the 
glass when hot.

In the event that you break your glass by impact, 
purchase your replacement from an authorized 
Regency dealer only, and follow our step-by-step 
instructions for replacement.

Remove the fl ush door front. Remove the 4 
glass clips from each corner. Slide in the new 
replacement glass. Push the 4 glass clips back 
onto the frame.  The glass must have gasket-
ing around it.

1)  Remove the door from the unit and place on 

a soft surface to prevent scratching.

2)  Remove the nuts holding the glass clips in 

place and remove.

3)   Replace the glass. The glass must have 

5)  Reverse the previous steps, replace the glass 

clips and fasten with the nuts but do not over 
tighten, as this can break the glass.

6)  Replace door on the stove and check the 

seal.