Harman Stove Company 1-90-797000 Manual De Usuario

Save These Instructions 3-90-798 Dry Seasoned Wood Only!

Oakleaf Woodburning stove

d. Optional Blower Installation

The optional blower kit #1-00-797032 installs easily to

the rear of the Oakleaf.

Hold the blower assembly into place and secure it

with the two bolts provided. You'll need a 3/8" wrench

or socket to tighten the bolts.

secure blower with one bolt on each

end of the mounting plate.

WARNING

ROuTE POWER CORd AWAy fROM THE APPLIANCE.

dO NOT RuN THE CORd uNdER OR IN fRONT Of

THE APPLIANCE.

Notice: When installing the optional blower, the

upper rear shield must be moved upward to create

the air passage.

Loosen the eight screws to remove the rear shield.

Raise the shield to the upper set of holes, re-install

the shield, and tighten the screws.

E. Optional Rear-vent Rear shield

Whenever a rear vent configuration is used, the upper

rear heat shield, #1-00-797070 must be purchased

and installed, to accomodate the flue collar. There

are eight screws that secure the existing shield.

You'll need to break away the tabbed portion of the

lower shield flue cut-out. Remove the screws from

the top-vent shield and install the rear vent shield in

it's place. Height adjustment for blower use is done

the same as with the top-vent shield in place. See

D. Optional Blower Installation (above) for detailed

instructions.

f. Optional Bottom Heat shield

Part #1-00-797058

must be purchased and installed

whenever the Oakleaf is installed on a protected com-

bustible floor. The shield installs on four bolts that are

protruding downward from the base of the stove body.

Slide the shield under the stove from the back, as

this is the only way it will fit. Lift into place guiding the

bolts through the holes in the shield and secure with

the nuts that are included with the shield.

shown with lower shield

knockout removed.

If not installing the

optional blower, the

upper knockout will

need to be removed.

Plug the blower into a properly grounded electrical

outlet.

You can turn the blower on at any time using the

rocker switch on the rear of the blower housing. Set-

ting the switch to "AUTO" will keep the blower off until

there is a significant amount of heat from the stove.

In this setting, the blower will also shut off when the

stove cools. Keep the blower on low speed or off dur-

ing low fires. As you get out of the low burn range, the

speed can be set wherever desired, or kept off.