Windsor 10052250 Manual De Usuario

 CUTTER 24V   86039070   04/10/07 

 

 
The front squeegee blade allows solution to pass 
through channels in the blade into the squeegee 
assembly while maintaining vacuum to provide lift.  
The front blade has four wear surfaces and can be 
rotated for extended life. The front blade should not 
require regular replacement under normal use.   
 
The rear blade wipes the floor to a near dry 
condition.  It is important the rear blade be in good 
condition to properly do its job.  As with the front, 
each squeegee blade assembly has four wear 
surfaces for extended service. 
 
Check both the front and rear squeegee blades for 
damage, wear, and adjustment each day in the pre-
run check.  Change the front blade if it is torn or has 
an uneven edge.  Change the rear blade if it is less 
than 1/2 the original thickness.   
 

 
Adjusting the squeegee is a two-part process.  First, 
the squeegee assembly must have correct pitch in 
order for the squeegee blade to have the same 
deflection at each tip as well as the center.  The 
knob on the squeegee linkage controls the pitch 
adjustment.  The second adjustment is the 
deflection.  Knobs on each end of the squeegee 
control this.  
 
 
 
 
 
 
 
 
 
 
 
 
 

 
1.  With the squeegee in the up position, turn key 

switch “OFF”. 

2.  Disconnect vacuum hose from squeegee and 

loosen both knobs. 

3.  Pull squeegee assembly rearward from the 

lifting carrier. 

4.  Inspect or repair as necessary and reinstall.

 
1.  With the squeegee in the up position, turn key 

switch “OFF”. 

FOR SAFETY: Before leaving or servicing 
machine; stop on level surface, turn off machine 
and remove key. 
2.  Remove the squeegee assembly from the 

machine.  Unlatch and remove blade retainer 
strap and remove squeegee blade. 

3.  Rotate the squeegee to new edge position or 

replace as required.  Each blade has four new 
edge positions. 

4.  Install blade on locating pins of squeegee 

assembly. 

5.  Install squeegee retainer strap. 
6.  Fasten and lock latch, adjust latch only tight 

enough to take up slack in retaining strap. 

 

 
1.  With the squeegee in the up position, turn key 

switch “OFF”. 

2.  Remove the squeegee from the machine.  

Loosen three thumbscrews and remove the 
retainer strap and squeegee blade. 

3.  Rotate the squeegee to new edge position or 

replace as required.  Each blade has four new 
edge positions.  When installing the front blade, 
tighten the center thumbscrew first.  Insure that 
the retainer strap is pressed against the blade 
before tightening the outer screws. 

 

 

 

 

SQUEEGEE DEFLECTION