Yamaha RX-V3800 Manual De Usuario

This unit employs the YPAO (Yamaha Parametric Room Acoustic Optimizer) technology which lets you avoid 
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied 
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening 
environment.

• Be advised that it is normal for loud test tones to be output 

during the automatic setup procedure.

• To achieve the best results, make sure the room is as quiet as 

possible while the automatic setup procedure is in progress. If 
there is too much ambient noise, the results may not be 
satisfactory.

y
• If an error occurs during the automatic setup procedure and an 

error or warning message appears in the GUI screen or in the 
front panel display, see the “Auto Setup” section in 
“Troubleshooting” on pages 135 and 136 for a complete list of 
error and warning messages and proper remedies.

• The initial setting for each parameter is indicated in bold.
• Before performing operations, set the operation mode selector 

on the remote control to D

.

■

❏

Speakers are connected appropriately.

❏

Headphones are disconnected from this unit.

❏

This unit and the video monitor are turned on.

❏

The connected subwoofer is turned on and the 
volume level is set to about half way (or slightly 
less).

❏

The crossover frequency controls of the 
connected subwoofer is set to the maximum.

❏

If you use the external amplifiers (see page 28), 
the amplifiers are turned on and the settings are 
appropriate.

❏

The room is sufficiently quiet.

“MIC ON” and “View OSD MENU” appears in the 
front panel display.

The following menu screen appears on the video 
monitor.

y
Following message appears in the front panel display after a 
while. You can only perform the automatic setup with the 
GUI menu.

M I C   O N
V I E W   O S D   M E N U

G U I

R X - V 3 8 0 0