Yamaha RX-V3800 Manual De Usuario

y
It is recommended that you use a tripod (etc.) to affix the 
optimizer microphone at the same height as your ears would 
be when you are seated in your listening position. You can 
use the attached screw of a tripod (etc.) to fix the optimizer 
microphone to the tripod (etc.).

4

ENTER

This unit starts the automatic setup procedure 
immediately. Loud test tones are output from each 
speaker during the automatic setup procedure. During 
the setup procedure, “Measuring...” appears in the 
GUI screen.

• During the automatic setup procedure, do not perform any 

operation on this unit.

• We recommend that you get out of the room while this unit 

is in the automatic setup procedure. Keep quiet when you 
leave the room. The necessary time for the automatic setup 
procedure may differ depending on the environment of the 
listening room and connected speakers (from 30 seconds 
to 3 minutes).

y
To stop the automatic setup procedure and set this unit to the 
pause mode, press one of the cursor buttons (4k / n / l / 
h) or 4

. In the pause mode, press 4k to retry the 

procedure, and 4

l to cancel the Auto Setup procedure.

• Press 4n and select “Setup” to set the measured 

values.

• Press 4k and select “Retry” to retry the automatic 

setup procedure. This unit starts the automatic 
setup procedure immediately again.

• Press 4h and select “Detail” to view information 

about measurement results and warning messages. 
In the information display, press 4k / n 
repeatedly to toggle between the parameters. For 
more details about warning messages, see the 
“Auto Setup” section in “Troubleshooting” on 
page 135.

• Press 4l and select “Exit” to exit from the Auto 

Setup procedure. If you select “Exit”, “Don’t 
Setup?” appears on the screen. To set the measured 
values and exit, select “Setup”. To cancel the 
settings and exit, select “Cancel”.

y
If you are not satisfied with the results or want to manually 
adjust each parameter, set the parameters in “Basic” (see 
page 91).

• If you change speakers, speaker positions, or the layout of 

your listening environment, run “Auto Setup” again to 
recalibrate your system.

• The distances displayed in the “Distance” results may be 

longer than the actual distance depending on the 
characteristics of your subwoofer or external amplifiers if 
you connect them.

• In the “Equalizing” results, different values may be set for 

the same band to provide finer adjustments.

Once you perform the next operation, this unit starts 
the automatic setup procedure immediately. For the 
accurate measurements, once you perform the next 
operation, we recommend that you get out of the room 
or move to the position where you do not interrupt the 
accurate measurements (for example, along the wall 
with no speakers installed nearby).

✓

✓

✓