Sony 4-168-043-14(1) Manual De Usuario

 

 

 

 

 

 

 

 

 

• Check that the components are connected 

correctly.

• Select the source component using the 

input buttons (page 35).

• Use a 75-ohm coaxial cable (not supplied) 

to connect the receiver to an outdoor FM 
antenna (aerial) as shown below. If you 
connect the receiver to an outdoor antenna 
(aerial), ground it against lightning. To 
prevent a gas explosion, do not connect the 
ground (earth) wire to a gas pipe.

• Check that the antennas (aerials) are 

connected securely. Adjust the antennas 
(aerials) and connect an external antenna 
(aerial), if necessary.

• The signal strength of the stations is too 

weak (when tuning in with automatic 
tuning). Use direct tuning.

• Make sure you set the tuning interval 

correctly (when tuning in AM stations 
with direct tuning).

• No stations have been preset or the preset 

stations have been cleared (when tuning 
by scanning preset stations). Preset the 
stations (page 40).

• Press DISPLAY repeatedly so that the 

frequency appears on the display.

• Make sure that you are tuned to an FM 

RDS station.

• Select a stronger FM station.

• Contact the radio station and find out 

whether they actually provide the service 
in question. If so, the service may be 
temporarily out of order.

* Models of area code ECE, CEK, AU1 only.

• Check the HDMI connection (page 23).
• Make sure “CTRL.HDMI” is set to 

“CTRL ON” in the HDMI menu (page 
58).

• Make sure the connected component is 

compatible with the Control for HDMI 
function.

• Check the Control for HDMI settings on 

the connected component. Refer to the 
operating instructions of the connected 
component.

• Repeat the procedures of “Preparing for 

the “BRAVIA” Sync” if you change the 
HDMI connection, connect/disconnect the 
AC power cord (mains lead), or when 
there is a power failure (page 47).

AM

Receiver

To ground

Ground (earth) 
wire (not supplied) 

Outdoor FM antenna (aerial)