Sony 4-168-043-14(1) Manual De Usuario

• Make sure the TV is compatible with the 

System Audio Control function.

• If the TV does not have System Audio 

Control function, set the “AUDIO.OUT” 
settings in HDMI menu to
– “TV+AMP” if you want to listen to the 

sound from the TV speaker and receiver.

– “AMP” if you want to listen to the sound 

from the receiver.

• When you connect the receiver to a video 

component (projector, etc.), sound may 
not be output from the receiver. In this 
case, select “AMP”.

• If you cannot listen to the sound of a 

component connected to the receiver
– Select appropriate input (BD, DVD, 

SAT/CATV) when you want to watch a 
program on a component connected via 
HDMI connection to the receiver. 

– Change the TV channel when you want 

to watch a TV broadcast.

– Select the component or input you want 

to watch when you watch a program on 
the component connected to the TV. 
Refer to the operating instructions of the 
TV on this operation.

• When the receiver is in standby mode, 

image and sound are output from the 
HDMI component selected the last time 
you turned off the receiver. If you are 
enjoying other component, play the 
component and perform the One-Touch 
Play operation, or turn on the receiver to 
select the HDMI component you want to 
enjoy. 

• Make sure “PASS.THRU” is set to “ON” 

in the HDMI menu if you connect 
components not compatible with the 
“BRAVIA” Sync to the receiver (page 64). 

• Point the remote at the remote sensor on 

the receiver.

• Remove any obstacles in the path between 

the remote and the receiver.

• Replace all the batteries in the remote with 

new ones, if they are weak.

• Make sure you select the correct input on 

the remote.

• The “AUTO.STBY” function is working 

If there is a malfunction, the display shows a 
message. You can check the condition of the 
system by the message. See the following table 
to solve the problem. If any problem persists, 
consult your nearest Sony dealer. 
If an error message appears while you perform
Auto Calibration, see “When error codes 
appear” (page 32) to solve the problem.

Irregular current is output to the speakers, or 
the upper panel of the receiver is covered 
with something. The receiver will 
automatically turn off after a few seconds. 
Check the speaker connection and turn on 
the power again.