Yamaha DSP-Z11 Manual De Usuario

■ Audio jacks
This unit has three types of audio jacks. Connection depends on the 
availability of audio jacks on your other components.

AUDIO jacks
For conventional analog audio signals transmitted via left and right 
analog audio cables. Connect red plugs to the right jacks and white 
plugs to the left jacks.

DIGITAL COAXIAL jacks
For digital audio signals transmitted via coaxial digital audio cables.

DIGITAL OPTICAL jacks
For digital audio signals transmitted via optical digital audio cables.

You can use the digital jacks to input PCM, Dolby Digital and DTS 
bitstreams. When you connect components to both the COAXIAL and 
OPTICAL jacks, priority is given to the signals input at the COAXIAL jack. 
All digital input jacks are compatible with 96-kHz sampling digital signals.

■ Video jacks
This unit has three types of video jacks. Connect the video input 
jacks on this unit to the video output jacks of the input source 
components to switch the audio and video sources simultaneously. 
Connection depends on the availability of input jacks on your video 
monitor. 

VIDEO jacks
For conventional composite video signals transmitted via composite 
video cables.

S VIDEO jacks
For S-video signals, separated into the luminance (Y) and 
chrominance (C) video signals transmitted on separate wires of S-
video cables.

COMPONENT VIDEO jacks
For component video signals, separated into the luminance (Y) and 
chrominance (P

B

, P

R

) video signals transmitted on separate wires of 

component video cables.

y

This unit is equipped with the video conversion function. See pages 29 and 
89 for details.

■ HDMI jack and cable plug
This unit has five HDMI input jacks and two HDMI output jacks for 
digital audio and video signal input/output.

y

• We recommend that you use a commercially available HDMI cable shorter 

than 5 meters (16 feet) with the HDMI logo printed on it.

• Use a conversion cable (HDMI jack 

↔

 DVI-D jack) to connect this unit to 

other DVI components.

• You can check the potential problem about the HDMI connection (see 

page 95).

• See page 139 for the information on the input signal capability of this unit 

for the HDMI connection.

• When you set “Standby Through” in “Manual Setup” to “On”, this unit 

allows the HDMI signals input at an HDMI IN jack to pass through this 
unit and output at an HDMI OUT jack (see page 94).

• Do not disconnect or connect the cable or turn off the power of the HDMI 

components connected to the HDMI OUT jacks on this unit while data is 
being transferred. Doing so may disrupt playback or cause noise.

• The HDMI OUT jacks output the audio signals input at the HDMI input 

jacks only when “Support Audio” is set to “Other” (see page 94).

• If you turn off the power of the video monitor connected to the HDMI 

OUT jacks via a DVI connection, this unit may fail to establish the 
connection to the component.

• The analog video signals input at the composite video, S-video and 

component video jacks can be digitally up-converted to be output at the 
HDMI OUT jacks. Set “Conversion” to “On” in “Manual Setup” (see 
page 89) to activate this feature.

• This unit is equipped with two HDMI OUT jacks, however cannot output 

the video signals to the both HDMI OUT jacks simultaneously. You can 
select the active HDMI OUT jack. See page 50 for details.

R

L

C

O

R

L

(Red)

(White)

(Orange)

P

B

Y

P

R

S

V

(Yellow)

(Green)

(Blue)

(Red)