Bosch 550 Manual De Usuario
MIC Series 550 Camera
| en
63
Bosch Security Systems, Inc.
User Manual
F.01U.239.454 | 3.0 | 2012.09
98
Find End Stops
Rotates the tilt axis first down, then up to its
mechanical limit stops. It then stores a "soft" limit a
few units back from these for normal use. Note:
Manual control is not available during this process.
99
Show Boot Message
Displays the boot/startup message that appears on the
video for a few seconds. This may be helpful to
determine the current software of the camera, without
having to do a full reboot.
198
Intermittent Wipe On
Triggers the wiper to wipe approximately twice every
60 seconds, instead of continuously, until the wipe
function is deactivated. This function is useful only on
systems with latching auxiliaries.
199
Intermittent Wipe Off
Deactivates the intermittent wipe function. If the wipe
function is activated, the wiper will wipe continuously
until deactivated.
204
Auto Home to Preset
With Auto Home turned on, the camera can be
configured to move to the home position (preset 1)
using the "Home To" setting. The amount of time
before this takes place can be set to 30 seconds, 1
minute, 5 minutes, or 1 hour using the "Home Time"
Setting in "Advanced Controls."
205
Auto Home to Tour
With Auto Home turned on, the camera can be
configured to move to start preset tour 1 using the
"Home To" setting. The amount of time before this
takes place can be set to 30 seconds, 1 minute, 5
minutes, or 1 hour using the "Home Time" Setting in
"Advanced Controls."
206
Auto Home Off
Enables the unit to remain stationary when set to OFF
or until the next user input.Forces the camera to
remain stationary when set to OFF or until the next
user input.
207
Multi Alarms Enable
Enables you to set up a separate position for each of
the eight alarm inputs. Any given alarm input triggers
the camera to move to the position to which it is
associated. To enable this function, turn on Auto Alarm
and Multi Alarm.
208
Multi Alarms Disable
Disables the Multi Alarms function.
209
Digital Zoom Disable
Disables the Digital Zoom function Provides both
optical and digital zoom. On some systems, there is the
option of selecting digital zoom; however, with others,
the control system always outputs commands to
continue into digital zoom, which may not always be
desirable. To stop this, there is an override function,
Digital Zoom, which, if turned off, will not go into
digital no matter what the keyboard sends out, and if
activated will allow digital zoom as the controller
dictates.
Preset
Number
Command
Description