Toshiba 6520c Manual De Usuario
e-STUDIO5520C/6520C/6530C
© 2008 TOSHIBA TEC CORPORATION All rights reserved
1-6
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
Procedures
* The service technician must perform the adjustment in accordance with the procedures below.
(1) Enter setting mode [08]. Change the value to adjust the density of a solid area during the copying/printing
operation.
• Use steps (a) to (b) to perform the adjustment.
(a) Enter setting mode [08]. Change the values for codes [2514/2515/2546] to adjust the developer bias
output value.
* The value to use varies depending on the paper type and color to adjust. Check the code to use in
accordance with the following "Code" list, and refer to the "Value" list to select a proper value.
In the Full color mode
Paper type
Color to adjust
[08] code
Subcode
Y (yellow)
0
M (magenta)
1
C (cyan)
2
Thick 1, 2
K (black)
08-2514
3
Y (yellow)
0
M (magenta)
1
C (cyan)
2
Full color
Thick 3, 4
Special 1, 2
Special 1, 2
K (black)
08-2546
3
In the Black mode
Paper type
Color to adjust
[08] code
Subcode
Plain paper 1, 2
K (single color)
08-2515 *
---
Thick 1 to 4
K (single color: When thick
paper is used in the Black
mode)
paper is used in the Black
mode)
08-2514 3
Black
Special 1, 2
K (single color: When
special paper is used in the
Black mode)
special paper is used in the
Black mode)
08-2546 3
* 08-2515 is available for e-STUDIO6530C only.
* The table below shows you the acceptable paper weight for the paper type.
Paper type
Acceptable paper weight
Thick 1
106 to 163 g/m²
Max. 60 lb. Cover
Thick 2
164 to 209 g/m²
Max. 110 lb. Index
Thick 3
210 to 256 g/m²
Max. 140 lb. Index
Full color /
Black
Thick 4
257 to 300 g/m²
Max. 110 lb. Cover
Special 1
Water-resistant paper (CoLaCa)
Full color /
Black
Special 2
Glossy paper (Eco-crystal)