Toshiba 6520c Manual De Usuario

 

e-STUDIO5520C/6520C/6530C 

© 2008 TOSHIBA TEC CORPORATION All rights reserved 

1-7 

0 

Value automatically set −80 Light 

1 

Value automatically set −60 

↑ 

2 

Value automatically set −40 

↑ 

3 

Value automatically set −20 

↑ 

4 

Value automatically set −10 

↑ 

5 

Value automatically set 

↑ 

6 

Value automatically set +10 

Default 

7 

Value automatically set +20 

↓ 

8 

Value automatically set +40 

↓ 

9 

Value automatically set +60 

↓ 

10 

Value automatically set +80 

Dark 

* Decreasing the value will make the solid colored area become lighter (decrease the amount of toner 

on the solid colored area).  On the other hand, increasing the value will make the solid colored area 
become darker (increase the amount of toner on the area). 

 

(b) Enter adjustment mode [05], select code [396], and then press the [START] button.  

After the image quality control is finished, perform printing to check the image quality of the solid 
colored area. 

 

* The changed setting values for 08-2514/2515/2546 will be effective for the image printed 

immediately after the change. When these values are changed, performing image quality control 
with 05-396 is recommended. 

 

 

Repeat procedures (a) to (b) as required in order to change the setting value so that the solid colored area 
becomes your desired density. 
Since the density of a gradation area (halftone), such as a photograph, is adjusted as well as that of a solid 
colored image, follow the procedure below. 

 
(2)  Perform automatic calibration for each type of paper whose density has been adjusted by means of the 

following flowchart. 
* This flowchart is common for the Full color and Black modes. 

0:   No automatic 

calibration for each 

paper type 

Set "1" for code 08-9059. 

Start (Offsetting correction of contrast potential has been set.) 

Perform automatic calibration 

Finish 

1:   Automatic calibration 

for each paper type 

Value for 08-9059