Cisco Systems 1552H Manual De Usuario

Slide the liquid-tight adapter towards the access point, and screw the threaded end of the adapter into the 
access point, and hand-tighten.

Use an adjustable wrench, a 22-mm socket, or a Sealcon S-2200-WR wrench to tighten the threaded end 
of the adapter to 6 to 7 ft lbs (8.1 to 9.5 Nm).

Use an adjustable wrench and tighten the round end of the adapter to 2.7 to 3.2 ft lbs (3.66 to 4.34 Nm).

Ensure that the antennas are connected to the access point before you apply power to the access point.

Route your Ethernet cable, and cut off any excess cable.

Install an RJ-45 connector on the unterminated cable end, and insert it into the power injector. For typical 
installation components, see 

Turn on power to the power injector.

The Cisco Aironet 1550 series outdoor mesh access point supports these AC power cord options:

40-ft (12.2-m) power cord (AIR-CORD-R3P-40NA=) for light pole installations in the US and 
Canada.

40-ft (12.2-m) power cord (AIR-CORD-R3P-40UE=) for light pole installations in the European 
Union.

4-ft (1.2-m) streetlight power tap adapter (AIR-PWR-ST-LT-R3P=) for light pole installations in the 
US and Canada.

A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement 
1022

Prior to connecting or disconnecting a power cord, you must remove AC power from the power cord 
using a suitable service disconnect.

European Union users need to install a country-specific plug to the blunt cut end of the cable assembly.

In all installations, the detachable power cord (pluggable Type B) must be an approved type acceptable 
to the authorities in the country where the unit is sold, and must meet all local and national electrical 
codes.