3com MIC-3365 Manual De Usuario

After the TurboCom software is installed, proceed to the 
“Placing and Receiving Calls” section in Chapter 2 of the 
3Com Impact ISDN External Digital Modem User Guide.

To configure the digital modem for an IBM PC or compatible 
computer using DOS:

1 Create a directory on the hard drive, insert the 3Com 

Impact DOS & Windows Installation Diagnostic Utilities 
diskette into the PC’s diskette drive, and copy all the files 
from the utility diskette to the hard drive. 

Copy the files to a new DOS directory. For example, to create a 
directory dddd on your C drive at the C:\> DOS prompt, type:

To copy all files from the diskette to a directory \dddd at the 
A:\> DOS prompt, type:

2 Execute INSTALL from the hard drive.

At the C:\> DOS prompt, type:

The configuration program launches and presents the
Port Settings screen. To move the cursor around the screen, 
use the [Up Arrow] and [Down Arrow] keys. To select a 
parameter, use the [Space Bar]. 

3 Use the [Space Bar] to select the digital modem’s

COM port and COM port data rate. 

This sets the speed of communication between the
3Com Impact digital modem and the computer during 
configuration.

When you select the port, the standard interrupt (IRQ) 
associated with that port is automatically chosen. Select the 
COM port data rate based on the data rate required by the 
destination digital modem and the maximum data rate 
supported by your computer’s COM port. 

09-0700-002  Page 11  Sunday, December 22, 1996  3:40 PM