3com MIC-3365 Manual De Usuario

3C

OM

 I

MPACT

 ISDN E

XTERNAL

 D

IGITAL

 M

ODEM

 Q

UICK

 S

TART

 I

NSTRUCTIONS

9 If you have a second telephone number associated with 

your ISDN telephone line (some telephone companies 
require two), enter the number and corresponding SPID in 
the appropriate fields in the Number 2 area.

10 Specify which device should receive the calls coming to 

Telephone Number 2. 

11 Click the Configure button to download the parameters 

listed in steps 5 through 10 to your digital modem’s
S registers.

12 If you have changed the Telephone Company Switch type, 

you must reset the digital modem by turning the power 
switch off and then on.

13 Verify the configuration.

Check the status bar (located beneath the Help, Tools, 
Configure, and Exit buttons of the Configuration dialog box) 
to verify correct configuration. If the parameters were 
configured accurately and the digital modem is ready to 
send and receive calls, the status bar fields will appear as 
shown below. Note that the TEI number(s) are not configured 
by the user. The TEI number is provided by the telephone 
company for informational purposes only.

■

Layer 1: UP

■

SPID 1: Init

■

TEI 1: Number from 0 to 127

■

SPID 2: Init (if required)

■

TEI 2: Number from 0 to 127 (if required)

14 Click Exit to leave the utility.

This completes the configuration procedure. 

15 Install the TurboCom software.

Refer to the installation instructions that came with the 
TurboCom software.

,

09-0700-002  Page 10  Sunday, December 22, 1996  3:40 PM