Linksys WET11 Manual De Usuario

12

or fewer alphanumeric characters. It must match the passphrase of your wireless network and is compatible 
with Linksys wireless products only. (You will have to enter the WEP key(s) manually on any non-Linksys 
wireless products.)

10. If you entered a Passphrase, then you will see the automatically generated WEP key in the Key 1 field, shown 

in Figure 5-9. Click the Next button, and proceed to step 11.

If you did not enter a Passphrase, then enter a WEP key in the Key 1 field. If you are using 64-bit WEP 
encryption, then the key must consist of exactly 10 hexadecimal characters. If you are using 128-bit WEP 
encryption, then the key must consist of exactly 26 hexadecimal characters. Valid hexadecimal characters 
are “0”-“9” and “A”-“F”. Then click the Next button, and proceed to step 11.

11. Review your settings on the Confirmation screen, shown in Figure 5-10. Write down the Bridge’s IP Address if 

you want to configure advanced settings through the Bridge’s Web-based Utility. Click the Yes button to save 
these settings. Click the No button to exit the Setup Wizard.

12. The next screen, shown in Figure 5-11, shows that the configuration is complete. To configure any other 

Wireless-B Ethernet Bridges on your network, run this Setup Wizard again. To register the Bridge, click the 
Online Registration button. To exit the Setup Wizard, click the Exit button.