Cisco Systems 7500 Series Manual De Usuario
7-11
Cisco 7500 Series Installation and Configuration Guide
OL-5008-03 B0
Chapter 7 Maintaining Your Cisco 7513, Cisco 7513-MX, and Cisco 7576 Router
Maintenance Procedures for the Cisco 7513, Cisco 7513-MX, and Cisco 7576
Step 4
When the blower is all the way into the chassis opening, tighten the captive installation screws on the
front of the blower module.
front of the blower module.
This completes the blower module removal and replacement procedure.
Removing and Replacing the Cisco 7513, Cisco 7513-MX, and Cisco 7576
Chassis Cover Panels
Chassis Cover Panels
Each cover panel on the Cisco 7513, Cisco 7513-MX, and Cisco 7576 has four fasteners that secure the
panels to the front of the chassis. The following procedures describe how to remove and replace the front
cover panels.
panels to the front of the chassis. The following procedures describe how to remove and replace the front
cover panels.
Step 1
Use a 3/16-inch flat-blade screwdriver to gently loosen the top of each cover panel.
Step 2
Pull the top of the upper panel out about 2 inches (5.08 cm); grasp the sides and carefully pull it outward,
away from the chassis. Repeat this for the bottom panel.
away from the chassis. Repeat this for the bottom panel.
Note
See the appropriate sections depending on the replacement procedures you need to perform. Then, to
replace the chassis cover panels, proceed to Step 3.
replace the chassis cover panels, proceed to Step 3.