Cisco Systems 7500 Series Manual De Usuario
7-9
Cisco 7500 Series Installation and Configuration Guide
OL-5008-03 B0
Chapter 7 Maintaining Your Cisco 7513, Cisco 7513-MX, and Cisco 7576 Router
Maintenance Procedures for the Cisco 7513, Cisco 7513-MX, and Cisco 7576
Installing the Card Cage Assembly
Use the following procedure to install the card cage assembly.
Caution
The electronic components on the rear of the backplane are completely exposed when the card cage and
backplane assembly is removed from the chassis. To prevent damaging these components, carefully slide
the assembly into the chassis opening.
backplane assembly is removed from the chassis. To prevent damaging these components, carefully slide
the assembly into the chassis opening.
Figure 7-7
Installing the Card Cage Assembly
Step 1
Carefully lift the card cage assembly, place it into the chassis opening, and slide the assembly into the
chassis opening until the left and right flanges on the card cage are flush with the chassis flanges.
chassis opening until the left and right flanges on the card cage are flush with the chassis flanges.
Step 2
Squeeze the card cage and chassis flanges together, and tighten each captive screw. Do not overtighten
the captive screws.
the captive screws.
Step 3
Carefully replace the processor modules in the card cage. (See the procedure shown in
Step 4
Reinstall the power supplies in the Cisco 7513, Cisco 7513-MX, or Cisco 7576. (See the
.)
This completes the procedure for installing the card cage assembly in the Cisco 7513,
Cisco 7513-MX, and Cisco 7576.
Cisco 7513-MX, and Cisco 7576.
H8819
POWER
A
POWER
B
Captive screw
Captive screw
Captive screw
Captive screw
Card cage
side flange
side flange
Air intake grill
Card cage
side flange
side flange