Cisco Systems RV130W Manual De Usuario

Configuring Basic Wireless Settings

Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide

63

 

If you chose B/G/N-Mixed, N-Only, or G/N Mixed, in the Wireless Band Selection 
field, select the wireless bandwidth on your network (20MHz or 20/40MHz). If 
you chose N-Only, you must use WPA2 security on your network. See 

.

In the Wireless Channel field, choose the wireless channel from the drop-down 
menu.

In the AP Management VLAN field, choose VLAN 1 if you are using the default 
settings.

If you create additional VLANs, choose a value that corresponds with the VLAN 
configured on other switches in the network. This is done for security purposes. 
You might need to change the management VLAN to limit access to Device 
Manager.

(Optional) In the U-APSD (WMM Power Save) field, check Enable to enable the 
Unscheduled Automatic Power Save Delivery (U-APSD) feature, also referred to as 
WMM Power Save, which allows the radio to conserve power.

U-APSD is a power-saving scheme optimized for real-time applications, such as 
VoIP, transferring full-duplex data over WLAN. By classifying outgoing IP traffic as 
voice data, these types of applications can increase battery life by approximately 
25% and minimize transmit delays.

(Optional) Configure the settings of the four wireless networks (see 

). 

Click Save.

The Wireless Table on the Basic Settings page lists the settings of the four 
wireless networks supported on the device.

To configure wireless network settings:

Check the box for the networks that you want to configure.

Click Edit.

Configure the following settings: