Cisco Systems CISCO7201 Manual De Usuario
2-7
Cisco 7201 Installation and Configuration Guide
OL-11364-04
Chapter 2 Installing the Cisco 7201 Router
Installing the Router
Attaching the Chassis Rack-Mount and Cable-Management Brackets
This section explains how to install the rack-mount and cable-management brackets at the front and the
rear of a Cisco 7201 router. Before installing the chassis in the rack, you must install a rack-mount
bracket on each side of the front or rear of the chassis.
rear of a Cisco 7201 router. Before installing the chassis in the rack, you must install a rack-mount
bracket on each side of the front or rear of the chassis.
The parts and tools required for installing the rack-mount brackets and cable-management bracket are
listed in the
listed in the
Installing Rack-Mount Brackets on the Front of the Chassis
Figure 2-3
Attaching the Rack-Mount Brackets to the Front of the Chassis
shows the brackets being attached for a front rack-mount.
To install the rack-mount and cable-management brackets on a Cisco 7201 router for a front rack-mount
configuration, complete the following steps:
configuration, complete the following steps:
Step 1
Locate the threaded holes in the front sides of the chassis.
Step 2
Align the rack-mount bracket to the rack-mount bracket holes on the side of the router.
Step 3
Remove any existing cover screws from the front sides of the chassis that align with the rack-mount
bracket holes and then realign the bracket. (You should have to remove one cover screw from each side
of the chassis.)
bracket holes and then realign the bracket. (You should have to remove one cover screw from each side
of the chassis.)
Step 4
Insert and tighten two 6-32 x 0.25-in. screws in the two holes nearest the front of the chassis.
Step 5
Insert and tighten the longer M3 x 8-mm screw in the hole nearest the rear of the chassis. (This screw
replaces the cover screw that you removed in Step 3.)
replaces the cover screw that you removed in Step 3.)
Step 6
Repeat Step 1 through Step 5 on the other side of the router.
This completes the steps for attaching the rack-mount brackets to the Cisco 7201 router.
1
Rack-mount bracket
3
Two M3 x 8-mm screws
2
Four 6-32 x 0.25-in. screws
281124
EN
AB
LE
D
RX
C
EL
LS
RX
C
AR
RIE
R
RX
A
LA
RM
ATM
GE 0/0
GE 0/1
GE 0/2
GE 0/3
AUX
CONSOLE
MNGMNT USE O
NLY
FE
LINK
0
FE 0/0
RJ45
SFP
SFP
SFP
SFP
LINK/ACTV
ALARM
PWR OK
STATUS
CF
ACTV
COMPACT FLASH
LINK/ACTV
RX
TX
LINK/ACTV
LINK/ACTV
RX
TX
EN
RJ45
EN
PA
SLOT 1
SLOT 1
2
3
1
Cisco 7201