Cisco Systems IPMUX-1E Manual De Usuario
IPmux-1/1E Installation and Operation Manual
Appendix E Configuration Menus
IPmux-1 E1/T1 Configuration
E-17
E.4 IPmux-1 E1/T1 Configuration
IPmux-1 automatically detects whether the interface is E1 or T1, and the
appropriate menu appears (see
appropriate menu appears (see
E1 Configuration
E1 CONFIGURATION
1. Channel Status
Enable
2. Transmit Clock Source
Adaptive
3. Loopback State
Disable
4. Rx. Sensitivity
-10dB
5. Line Type
CRC4 enable
6. Idle Code
7E
7. Uplink Fail Alarm Behavior Cond.
8. Signaling Mode
CAS enable
9. Cond. Data Pattern
FF
A. Cond. CAS (ABCD) Pattern
01
ESC. Exit
Select item from the menu.
Use <Esc> key or keys <1> to <9>
Figure E-24. E1 Physical Layer Configuration Menu
When “unframed” mode is selected, the Idle Code, Signaling Mode, Cond Data
Pattern and Cond CAS Pattern fields are not present.
When CAS Disabled is selected, the Cond CAS Pattern field is not present.
Pattern and Cond CAS Pattern fields are not present.
When CAS Disabled is selected, the Cond CAS Pattern field is not present.
Table E-12. E1 Physical Layer Configuration Parameters
Parameter Possible
Values
Remarks
Channel Status
Enable
Disable
Disable
Detection of LOS alarm
No detection of LOS alarm
Default:
No detection of LOS alarm
Default:
Enable
Transmit Clock Source
Adaptive
Loopback
Internal
Loopback
Internal
Adaptive clock regeneration
E1 recovered receive clock is used as the transmit clock
Local clock source is used
Default:
E1 recovered receive clock is used as the transmit clock
Local clock source is used
Default:
Adaptive
Note
Main Menu
↓
2. Configuration (E1)
↓
2. E1/T1
Configuration
Configuration