Cisco Systems ASR 1000 Series Manual De Usuario
5-6
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-03
Chapter 5 Cisco ASR 1004 Router Overview and Installation
Guidelines for an Equipment Shelf or Tabletop Installation
•
Install and use the cable-management brackets included with the Cisco ASR 1004 Router to keep
cables organized and out of the way of the cards and processors. Ensure that cables from other
equipment already installed in the rack do not impair access to the cards or require you to disconnect
cables unnecessarily to perform equipment maintenance or upgrades.
cables organized and out of the way of the cards and processors. Ensure that cables from other
equipment already installed in the rack do not impair access to the cards or require you to disconnect
cables unnecessarily to perform equipment maintenance or upgrades.
•
Install rack stabilizers (if available) before you mount the chassis.
•
Provide an adequate chassis ground (earth) connection for your router chassis.
In addition to the preceding guidelines, review the precautions for avoiding excessive temperature
conditions in the
conditions in the
provides the Cisco ASR 1004 Router dimensions and weight information.
Guidelines for an Equipment Shelf or Tabletop Installation
The chassis should already be in the area where you will install it. If you have not determined where to
install your chassis, see
install your chassis, see
site considerations.
If you are not rack-mounting your Cisco ASR1000 series chassis, place it on a sturdy equipment shelf
or tabletop.
or tabletop.
When installing the Cisco ASR 1004 Router on an equipment shelf or tabletop, ensure that the surface
is clean and that you have considered the following:
is clean and that you have considered the following:
•
The Cisco ASR 1004 Router requires at least 3 inches (7.62 cm) of clearance at the inlet and exhaust
vents (the front and top/rear sides of the chassis).
vents (the front and top/rear sides of the chassis).
•
The Cisco ASR 1004 Router should be installed off the floor. Dust that accumulates on the floor is
drawn into the interior of the router by the cooling fans. Excessive dust inside the router can cause
overtemperature conditions and component failures.
drawn into the interior of the router by the cooling fans. Excessive dust inside the router can cause
overtemperature conditions and component failures.
•
There must be approximately 19 inches (48.3 cm) of clearance at the front and rear of the chassis to
install and replace FRUs, or to access network cables and equipment.
install and replace FRUs, or to access network cables and equipment.
•
The Cisco ASR 1004 Router needs adequate ventilation. Do not install it in an enclosed cabinet
where ventilation is inadequate.
where ventilation is inadequate.
Table 5-1
Cisco ASR 1004 Router Dimensions and Weight
Cisco ASR 1004 Dimensions
Depth
22.50 in. (57.15 cm)
(including card handles, cable-management brackets, power
supply handles).
supply handles).
Height
6.95 in. (17.653cm) (4 rack-mount per EIA RS-310)
Width
17.25 in. (43.815 cm) (19 inch rack- mount or optional 23
Telco rack mount)
Telco rack mount)
Weight
50 pounds (fully configured)
22.6796 kg