Cisco Systems ASR 1000 Series Manual De Usuario
6-11
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-03
Chapter 6 Cisco ASR 1002 Router Overview and Installation
Guidelines for an Equipment Shelf or Tabletop Installation
•
Install rack stabilizers (if available) before you mount the chassis.
•
Provide an adequate chassis ground (earth) connection for your router chassis.
In addition to the preceding guidelines, review the precautions for avoiding excessive temperature
conditions in the
conditions in the
.
Guidelines for an Equipment Shelf or Tabletop Installation
The chassis should already be in the area where you will install it. If you have not determined where to
install your chassis, see
install your chassis, see
site considerations.
If you are not rack-mounting your Cisco ASR1000 series chassis, place it on a sturdy equipment shelf
or tabletop.
or tabletop.
When installing the Cisco ASR 1002 Router on an equipment shelf or tabletop, ensure that the surface
is clean and that you have considered the following:
is clean and that you have considered the following:
•
The Cisco ASR 1002 Router requires at least 3 inches (7.62 cm) of clearance at the inlet and exhaust
vents (the front and top/rear sides of the chassis).
vents (the front and top/rear sides of the chassis).
•
The Cisco ASR 1002 Router should be installed off the floor. Dust that accumulates on the floor is
drawn into the interior of the router by the cooling fans. Excessive dust inside the router can cause
overtemperature conditions and component failures.
drawn into the interior of the router by the cooling fans. Excessive dust inside the router can cause
overtemperature conditions and component failures.
•
There must be approximately 19 inches (48.3 cm) of clearance at the front and rear of the chassis to
install and replace FRUs, or to access network cables and equipment.
install and replace FRUs, or to access network cables and equipment.
•
The Cisco ASR 1002 Router needs adequate ventilation. Do not install it in an enclosed cabinet
where ventilation is inadequate.
where ventilation is inadequate.
•
Have the cable-management bracket available if you plan to install it on the front of the chassis.
•
An adequate chassis ground (earth) connection exists for your router chassis (see the
).
•
Always follow proper lifting practices as outlined in the
,
when handling the chassis.
Table 6-5
Cisco ASR 1002 Router Dimensions and Weight
Cisco ASR 1002 Dimensions
Depth
22.50 in. (57.15 cm)
(including card handles, cable-management brackets, power
supply handles).
supply handles).
Height
3.47 in. (8.813 cm) - 2RU rack-mount per EIA RS-310
Width
17.25 in. (43.815 cm) - 19 inch rack-mount
Weight
40 lb (18.143 k) - fully configured