Cisco Systems OL-20932-02 Manual De Usuario

The following steps are an example of the main installation and configuration tasks for a Cisco 
Physical  Access Control system. The exact procedure and order of installation for your system may vary. 

Unpack and mount the Cisco Physical Access Gateway. 

Unpack and mount optional reader, input or output modules, if necessary.

Connect door readers, input and output devices to the Cisco Physical Access Gateway or optional 
modules.

Connect power to the Cisco Physical Access Gateway and any optional modules.

Connect an Ethernet cable from a PC to the ETH1 interface on the Gateway module. 

To enter the Gateway initial configuration, be sure to connect your PC to the ETH1 port. The 
ETH0 port is used for network communication. 

Open a web browser on your PC and enter 

https://192.168.1.42

. This URL opens the web-based 

configuration page.

Be sure to include the s in 

https://

. This connects your browser to the secure URL. 

Enter the default username and password:

default username: 

default password: 

Enter and save the Network settings in the Initial Setup window. See the 

. Wait until the Gateway resets and the web 

browser displays the screen Network Settings Applied.

Verify the connections to the optional modules, door readers and other input and output devices. 

Connect an Ethernet cable from the Gateway ETH0 port to the IP network, and verify IP network 
connectivity.

Perform additional configuration, verification, and monitoring tasks as described in the 

.