Cisco Systems OL-20932-02 Manual De Usuario

 shows the modules for a Cisco Physical Access Control system. 

Mandatory module.

Connects up to two doors 
using the 10 pin Wiegand 
reader port, which can be 
configured as two 
five-pin ports.

Connects up to 15 
optional expansion 
modules using a 
three-wire CAN bus.

1

Power-over-Ethernet 
(POE) or 12 through 24V 
DC

Two Ethernet ports

Three output ports: 
Form C contacts rated at 
5A 30VDC 

Three supervised input 
ports

2

Tamper & Power Fail 
inputs (can be configured 
as additional 
unsupervised inputs)

One RS-485 serial port 
(not supported in this 
release).

1.

The modules are connected using the CAN1 interface. The CAN2 interface is not supported in this release.

2.

A supervised input supports four states: normal, alarm, open and short. An unsupervised input only indicates normal or alarm.

Requires connection to 
an Access Gateway using 
a three-wire CAN bus. 

Connects up to two doors 
using the 10 pin Wiegand 
reader port, which can be 
configured as two 5 pin 
ports.

Power: 12 through 24V 
DC

Three output ports: Form 
C contacts rated at 5A 
30VDC 

Three supervised input 
ports

Tamper & Power Fail 
inputs (can be configured 
as additional 
unsupervised inputs)

One RS-485 serial port 
(not supported in this 
release).

Requires connection to 
an Access Gateway using 
a three-wire CAN bus. 

10 supervised input ports

Example inputs are: Push 
button switches, Glass 
Break sensors, or any 
contact closure input. 
circuit

Power: 12 through 24V 
DC

Tamper & Power Fail 
inputs (can be configured 
as additional 
unsupervised ports)

Requires connection to 
an Access Gateway using 
a three-wire CAN bus. 

8 output ports: Form C 
contacts rated at 5A 
30VDC 

Example outputs are: 
lights, LEDs, or any 
contact closure output 
circuit.

Power: 12 through 24V 
DC

Tamper & Power Fail 
inputs (can be configured 
as additional 
unsupervised ports)

Cisco Physical

Access Gateway

Reader
Module

Input

Module

Output

Module

187057