Cisco Systems OL-20932-02 Manual De Usuario

 describes the Gateway module status LEDs: 

 

Installing the Cisco Reader Module is similar to installing the Gateway, except for the following:

There are no Ethernet ports. The Cisco Reader Module is not directly connected to the IP network, 
and is not directly configured.

The Cisco Reader Module does not support Power over Ethernet (PoE). The device is connected to 
a DC power source.

The Cisco Reader Module must be terminated if it is the last device in a CAN wiring bus. See the 

 for more information.

Before you install a Cisco Reader Module, verify the following:

Verify that the module has access to a power source. See the 

 for more information.

Verify that you have the necessary mounting brackets or other hardware. See the 

.

To install the Cisco Reader Module, perform the following procedure:

Mount the module to a wall. See the 

 

for more information. 

Connect the module to the DC power source:

Insert a two-pin connector plug into the DC power port (

)

Connect the Voltage In (VIN) and ground (GND) wires. 

OFF

Input is not configured

GREEN

Input is configured and in normal state

BLINKING GREEN

Input is configured, and is receiving and alarm or other data.

BLINKING RED

Input is configured, short

RED

Input is configured, open

Off

Output not configured

Solid Green

Output configured and in default state

Blinking Green

Output configured and active