Cisco Systems OL-7396-01 Manual De Usuario

10-5

ATM Switch Router Software Configuration Guide

OL-7396-01

Chapter 10

Configuring ILMI

Configuring an ILMI Interface

ARP Server Address (s):

1122334455667788990011223344556677889900

The following example shows the ILMI status:

Switch# show atm ilmi-status

Interface : ATM0 Interface Type : Local

Configured Prefix(s) :

47.0091.8100.0000.0003.c386.b301

Interface : ATM3/0/0 Interface Type : Private NNI

ILMI VCC : (0, 16) ILMI Keepalive : Disabled

Configured Prefix(s) :

47.0091.8100.0000.0003.c386.b301

Interface : ATM3/0/3 Interface Type : Private NNI

ILMI VCC : (0, 16) ILMI Keepalive : Disabled

Configured Prefix(s) :

47.0091.8100.0000.0003.c386.b301

Configuring an ILMI Interface

To configure an ILMI interface, perform the following tasks, beginning in global configuration mode:

Note

If the ILMI VC (by default VCI = 16) is disabled, then the ILMI is disabled.

Examples

The following example shows how to enable ILMI autoconfiguration on ATM interface 3/0/3:

Switch(config)# interface atm 3/0/3

Switch(config-if)# atm auto-configuration

The following example shows how to enable ATM address registration on ATM interface 3/0/3:

Switch(config)# interface atm 3/0/3

Switch(config-if)# atm address-registration

Command

Purpose

Step 1

Switch(config)# interface atm
card/subcard/port[.vpt#]

Switch(config-if)#

Specifies an ATM interface and enters interface
configuration mode.

Step 2

Switch(config-if)# atm auto-configuration

Enables ILMI autoconfiguration, including
determination of interface protocol, version, and
side.

Step 3

Switch(config-if)# atm address-registration

Configures ILMI address registration for a
specified interface.

Step 4

Switch(config-if)# atm ilmi-keepalive [seconds
[retry number]]

Configures ILMI keepalive.