Cisco Systems OL-7396-01 Manual De Usuario

The following example shows the SNMP server ATM accounting configuration using the 
more system:running-config privileged EXEC command:

Switch# more system:running-config

Building configuration...

Current configuration:

!

<information deleted>

!

ip rcmd rcp-enable

ip rcmd remote-host dplatz 171.69.194.9 dplatz

ip rcmd remote-username dplatz

atm template-alias byte_wise 47.9*f8.33...

atm template-alias bit_set 47.9f9(1*0*)88ab...

atm template-alias training 47.1328...

atm accounting enable

atm accounting trap threshold 85

!

<information deleted>

no ip classless

atm route 47.0091.8100.0000.0000.0ca7.ce01... ATM3/0/0

snmp-server enable traps chassis-fail

snmp-server enable traps chassis-change

snmp-server enable traps atm-accounting

snmp-server host 1.2.3.4 public atm-accounting

!

<information deleted>

After the ATM accounting file is written to DRAM, you must configure TFTP to allow network requests 
to copy the accounting information to a host for processing

. 

To do this, use the following command in 

global configuration mode:

The following example shows how to allow TFTP service to copy the ATM accounting file acctng_file1 
to the IP access list of requesting host number 1:

Switch(config)# access-list 1 permit 10.1.1.1

Switch(config)# tftp-server atm-acct-ready:acctng_file1 1

For more information about access lists, see 

Switch(config)# access-list access-list-number 
{deny | permit} {source [source-wildcard] | any}

Defines a standard IP access list using a source 
address and wildcard or the any option default 
source 0.0.0.0 and source mask 255.255.255.255.

Switch(config)# tftp-server 
{atm-acct-active:acctng_file1 | 
atm-acct-ready:acctng_file1} ip-access-list

Allows TFTP to copy the ATM accounting file to 
an IP host in response to a read request.