Cisco Systems OL-7396-01 Manual De Usuario

To display your controller configuration, use the following EXEC command:

The configuration for controller E1 is displayed in the following example:

Switch# show controllers e1 0/0/0 tabular

E1 0/0/0 is up.

E1 0/0/0 is up.

 PAM state is Up

 4CE1 H/W Version: 3.1

  4CE1 F/W Version: 2.0

  No alarms detected.

  Framing is crc4, Line Code is HDB3, Clock Source is line.

  INTERVAL       LCV  PCV  CS  SELS LES  DM   ES  BES  SES  UAS  SS

  18:38-18:51     0    0   0    0    0    0    2    0   10  704   0 

You must follow the required steps to enable Frame Relay to ATM interworking on your ATM switch 
router. In addition, you can customize Frame Relay to ATM for your particular network needs and 
monitor Frame Relay to ATM connections. The following sections outline these tasks:

For information on how to customize your Frame Relay to ATM connections, see 

 and 

.

To set Frame Relay encapsulation on the serial interface, perform the following steps, beginning in 
global configuration mode:

Frame Relay supports encapsulation of all supported protocols in conformance with RFC 1490, allowing 
interoperability between multiple vendors. 

show controllers e1 card/subcard/port [brief 
| tabular]

Displays E1 controller configuration.

Switch(config)# interface serial 
card/subcard/port:cgn

Switch(config-if)# 

Selects the interface to be configured.

Switch(config-if)# encapsulation frame-relay 
ietf

Configures Frame Relay encapsulation.