Carrier Access Access Navigator Manual De Usuario
Access Navigator - Release 1.8
August 2003
18-81
CLI Language Reference
CLI Command List
Send DS1 Off
Purpose:
Stops (turns off) all qrss and prbs test patterns from the Access Navigator. This is
the default state of the system.
the default state of the system.
Security:
Level 2 (operator)
Syntax:
send ds1 <n> off
Example:
send ds1 9 off
Send Remote Loopdown
Purpose:
Sends an out-of-band (FDL) message to a remote Access Bank II over the Access
Navigator DS1 to loopdown all the remote Access Bank II interfaces. This command
is used to disable the following send remote loopup commands:
Navigator DS1 to loopdown all the remote Access Bank II interfaces. This command
is used to disable the following send remote loopup commands:
n
n
n
n
n
n
n
n
n
n
NOTE:
To check remote loopback status, use the read remote loopback
command. See Read Remote Loopback on
Security:
Level 2 (operator)
Syntax:
send remote <n> loopdown
Example:
send remote 9 loopdown
Message:
Loop command sent to remote.
Field
Description
n
DS1 number, 1 to 32, or a range of numbers such as 2-8,
Field
Description
n
DS1 number, 1 to 32