Samsung ML-3560 Series Manual De Usuario

Using Print Materials

4.7

Push the envelope levers upwards. The print quality will be 
enhanced.

:

 Push the envelope levers downwards when you 

print on materials other than envelopes.

Flex or fan the edge of the envelope stack to separate and 
load the envelopes into the Multi-Purpose Tray with the 
flap side down. The stamp area is on the left side and 
the end of the envelope with the stamp area enters the 
printer first. 

Squeeze the paper width guide and slide it to the edge of 
the envelope stack without causing it to bend.

When you print, set the paper source, type, and size 
properly in the software application. For details, see the 
Software Section. 

For details about setting on the control panel, see 
page 3.2.

After printing, push the envelope levers to their original 
positions, and close the Multi-Purpose Tray and the rear 
cover.

Open the Multi-Purpose Tray and pull the extender.

Open the rear cover and pull the extender.

Guidelines
• Only use labels recommended for laser printers.
• Verify that the labels’ adhesive material can tolerate fusing 

temperature of 195°C (383°F) for 0.1 second.

• Make sure that there is no exposed adhesive material 

between the labels. Exposed areas can cause labels to peel 
off during printing, which can cause paper jams. Exposed 
adhesive can also cause damage to printer components.

• Never print on the same sheet of labels more than once, or 

print on a partial sheet of labels.

• Do not use labels that are separating from the backing sheet 

or are wrinkled, bubbled, or damaged in any way.

• To prevent labels from sticking together, do not let the 

printed label sheets stack up as they are printed out.