Samsung ML-3560 Series Manual De Usuario

Using Print Materials

4.9

Preprinted paper is paper that has some type of printing on it 
before it is sent through the printer (paper that has a 
preprinted logo at the top of the page, for example).

Load letterheads into the tray you want to use, as shown 
in the figures below. Adjust the guides to fit the width of 
the paper stack.

When you print, set the paper source, type, and size 
properly in the software application. For details, see the 
Software Section. 

For details about setting on the control panel, see 
page 3.2.

Guidelines
• Letterheads must be printed with heat-resistant ink that will 

not melt, vaporize, or release hazardous emissions when 
subjected to the printer’s fusing temperature of 383 °F (195 
°C) for 0.1 second.

• Ink on letterheads must be non-flammable and should not 

adversely affect printer rollers.

• Forms and letterheads should be sealed in a moisture-proof 

wrapping to prevent changes during storage.

• Before you load preprinted paper, such as forms and 

letterheads, verify that the ink on the paper is dry. During 
the fusing process, wet ink can come off preprinted paper, 
reducing print quality.

Load with the design face 
down, bottom edge 
towards the printer.

Load with the design 
face up, top edge 
towards the printer.

Postcards, 3.5 by 5.83 in. (index) cards, and other custom-
sized materials can be printed with your printer. The minimum 
size is 76 by 127 mm (3 by 5 in.) and the maximum size is 216 
by 356 mm (8.5 by 14 in.).

Open the Multi-Purpose Tray and pull the extender.

Open the rear cover and pull the extender.

Load print material in the 

Multi-Purpose Tray

 with the 

print side up and short edge first. Adjust the guide to 
fit the width of the material stack.

When you print, set the paper source, type, and size 
properly in the software application. For details, see the 
Software Section. 

For details about setting on the control panel, see page 
page 3.2.

After printing, close the Multi-Purpose Tray and the rear 
cover.

Guidelines
• Always insert the short-edge into the Multi-Purpose Tray 

first. If you want to print in landscape mode, make this 
selection through your software. Inserting paper long-edge 
first may cause a paper jam.

• Do not load more than 10 cards into the Multi-Purpose Tray 

at a time.

• Do not print on media smaller than 76 mm (3 in.) wide or 

127 mm (5 in.) long.

• In the software application, set margins at least 6.4 mm 

(0.25 in.) away from the edges of the material.