Samsung SCX-6x22 Manual De Usuario

2.5   

<System setup>

Toner Save mode allows your machine to use less toner on each page. 
Activating this mode extends the life of the toner cartridge beyond what 
one would experience in the normal mode, but it reduces print quality.

To turn this mode on or off, press Toner Save. 

When PC-printing, you can also turn on or off Toner Save mode 
in the printer properties. See the Software Section.

Power Save mode allows your machine to reduce power consumption 
when it is not in actual use. You can turn this mode on and select a length 
of time for which the machine waits after a job is printed before it switches 
to a reduced power state.

Press Menu until System Setup appears on the bottom line of the 
display and press OK.

Press OK when Machine Setup appears.

Press the Scroll buttons until Power Save appears and press OK.

Press the Scroll buttons until On appears and press OK.

Press the Scroll buttons until the time setting you want appears and 
press OK.

Press Stop/Clear to return to Standby mode.

Scan Power Save mode allows you to save power by turning off the scan 
lamp. The scan lamp under the scanner glass automatically turns off 
when it is not in actual use to reduce power consumption and extend the 
life of the lamp. The lamp automatically wakes up after some warm-up 
time when you start scanning.

You can set the length of time for which the scan lamp waits after a scan 
job is completed before it switches to the power save mode. 

Press Menu until System Setup appears on the bottom line of the 
display and press OK.

Press OK when Machine Setup appears.

Press the Scroll buttons until Scan PWR Save appears and press 
OK.

Press the Scroll buttons until the time setting you want appears and 
press OK.

Press Stop/Clear to return to Standby mode.

You can set the amount of time a single print job is active before it must 
print.

The machine handles incoming data as a single job if it comes in within 
the specified time. When an error occurs while processing data from the 
computer and the data flow stops, the machine waits the specified time 
and then cancels printing if data flow does not resume.

Press Menu until System Setup appears on the bottom line of the 
display and press OK.

Press OK when Machine Setup appears.

Press the Scroll buttons until Job Timeout appears and press OK.

Press the Scroll buttons until the time setting you want appears and 
press OK.

Press Stop/Clear to return to Standby mode.

The atmospheric pressure could affect the printing quality. If you use the 
machine in over 1,500 mm height altitude area, set the Altitude as 
recommended in step 4 below.

Press Menu until System Setup appears on the bottom line of the 
display and press OK.

Press OK when Machine Setup appears.

Press the Scroll buttons until AltitudeAdjustment appears and 
press OK.

Press the Scroll buttons until the binding option you want appears.
• Plain: sets the machine to work best in altitude: 0 ~ 1500m.
• High: sets the machine to work best in altitude: 1500 ~ 2500m.
• Higher: sets the machine to work best in altitude: 2500 ~ 3500m.
• Highest: sets the machine to work best in altitude: 3500 ~ 4000m.

Press OK to save your selection.

Press Stop/Clear to return to Standby mode.

This is the option to set the machine to continue printing or not, in case 
the paper size you have set and the paper within the tray mismatches. 

Press Menu until System Setup appears on the bottom line of the 
display and press OK.

Press OK when Machine Setup appears.