Samsung CLP-325W Manual De Usuario

Wireless network setup (CLP-325W(K)/CLP-326W only)_ 49

•

The configured network address is unable to connect between your 

computer and machine.

-

For a DHCP network environment

The print receives the IP address automatically (DHCP) when 

computer is configured to DHCP.

-

For a Static network environment

The machine uses the static address when the computer is 

configured to static address.
For example:
If computer’s network information is as shown below:

-

IP address: 169.254.133.42

-

Subnet Mask: 255.255.0.0

Then, the machine’s network information should be as below:

-

IP address: 169.254.133. 43

-

Subnet Mask: 255.255.0.0 (Use the computer’s subnet mask.)

-

Gateway: 169.254.133.1

If problems occur while using the machine on a network, check the 

following: 

For information on the access point (or wireless router), refer to its 

own user's guide. 

•

Your computer, access point (or wireless router), or machine may not be 

turned on.

•

Check the wireless reception around the machine. If the reception is far 

from the machine or there is an obstacle, you might have difficulty 

receiving the signal. 

•

Cycle the power for the access point (or wireless router), machine, and 

computer. Sometimes cycling the power can recover network 

communication.

•

Check whether firewall software (V3 or Norton) is blocking the 

communication. 
If the computer and the machine is connected on the same network and 

it cannot be searched, firewall software might be blocking the 

communication. Refer to the user's guide for the software to turn it off 

and try searching for the machine again.

•

Check whether the machine's IP address is allocated correctly. You can 

check the IP address by printing the network configuration report.

•

Check whether the access point (or wireless router) has a configured 

security (password). If it has a password, refer to the access point (or 

wireless router) administrator.

•

Check whether the machine's IP address. Reinstall the machine driver 

and change the settings to connect to the machine on the network. Due 

to the characteristics of DHCP, the allocated IP address could change if 

the machine is not used for a long time or if the access point has been 

reset.

•

Check the wireless environment. You might not be able to connect to the 

network in the infrastructure environment where you need to type in a 

user's information before connecting to access point (or wireless router).

•

This machine only supports IEEE 802.11 b/g/n and Wi-Fi. Other wireless 

communication (Bluetooth) is not supported.

•

When using the Ad-hoc mode, for operating systems such as Windows 

Vista, you might need to set the wireless connection setting every time 

you use the wireless machine. 

•

You cannot use infrastructure mode and Ad-hoc mode at the same time 

for Samsung wireless network machines.

•

The machine is within the range of the wireless network.

•

The machine is located away from obstacles that could block the 

wireless signal.
Remove any large metal objects between the access point (or wireless 

router) and the machine.
Make sure the machine and wireless access point (or wireless router) 

are not separated by poles, walls, or support columns containing metal 

or concrete.

•

The machine is located away from other electronic devices that may 

interfere with the wireless signal.
Many devices can interfere with the wireless signal, including a 

microwave oven and some Bluetooth devices.