GarrettCom 6K32T Manual De Usuario

Magnum 6K32T & 6K32TRC Managed Switch          Installation and User Guide 05/07) 

 
 

17

 

 

.

.

SC or single mode SC or Long Reach SC ports.  For ports numbering, ports 1,3,5,7 are 

copper, ports 2 and 6 are fiber, ports 4 and 8 are not present.       

 

The four RJ-45 ports operate just like the 8-port copper module with auto-cross 

(MDIX) feature to eliminate the use of cross-over cable, and the two fiber ports operate 

at 100Mbps full-duplex (default). User mode control per port through the MNS software 

is also the same. 

On Magnum “4+2” Combo modules, there are four LED’s for each RJ-45 port, 

which indicate status the same as described for the 6K8-RJ45 in Section 2.2.3 above. The 

fiber port’s LEDs indicate status the same way as described for the SFF fiber modules in 

Section 2.2.2 above.  Color-coding on the panel of the module shows which LEDs 

belong to which port. 

 

The Magnum Combo six-port modules are also available with 4@ MTRJ 

100Mb mm SFF fiber and 2@10Mb fiber mm ST ports, and with 4@ RJ45 10/100 

copper and 2@10Mb fiber mm ST 

ports. The    

 4@ RJ-45 + 2@ 10 Mb ST 

operation of the SFF fiber 

and the RJ-45 half of the module is 

as described for those port types 

above.  For detailed information about 10Mb mm ST fiber half of the module, see 

Section 2.2.5. 

The 4port @10Mb ST fiber modules behave the same as the 8@100Mb ST 

fiber modules except for the 10Mb speed. For port numbering, ports 1, 2, 5, 6 are present, 

ports 3, 4. 7, 8 are not present. The default setup on the 10Mb fiber module is half-

duplex, which allows the Magnum 6K32T & 6K32TRC Switch to connect to any 10Mb 

hub or media converter or almost any other device with a 10Mb fiber Ethernet port. User 

mode control per port through the MNS software is the same as the other 6K32T & 

TX       LK     RX

 

 

 

1                                          5