Black Box KV162A Manual De Usuario

Choosing option 1 from the main menu will bring up a screen like that shown in Figure 10-3, displaying the
selected ServSwitch Multi’s current configuration information. You will be prompted for a chassis number
(address) before the table is displayed. Enter a remote chassis’ address, or press Enter at the prompt to see
information on the local chassis.

EPROM   FLASH

Chan  Card Type  HW Rev FW Rev  FW Rev   Serial #   Other Information

----  ---------  ------ ------  ------  ----------  -----------------

3-A  XPAC       B03    * A-05   -NA-   0123456789  PC + PS/2 mouse

3-B  XPAC       C00    * B03C   -NA-   1234567890  No cable attached

3-C  Empty

3-D  Empty

3-E  Empty

3-F  Empty

3-G  Empty

3-H  XPXT       A00      XB84  * XF82  2345678901  P1[N/C] P2[  4-F]

3-I  XPXT       A00      XB84  * XF82  3456789012  P1[N/C] P2[  5-F]

3-J  XPLU       C00    * B03C   -NA-   4567890123

3-K  XPDU       D01      C01C  * C04A  5678901234

3-L  XPXR       A00      XC15  * XG18  6789012345

3-M  XPXR       A00      XC15  * XG18  7890123456

3-N  LCI        C00    * B02B   -NA-   8901234567

* - Indicates active device

1. The “Chan” column lists the channel address of each component (Card or module). For Base Units, the option slot will

always be listed as channel “M,” and the local-console module will always be listed as channel “N.”

2. The “Card Type” column shows what type of component it is: “LCI”=Local-console module, “XPAC”=CPU-Interface Card,

“XPLU”=Universal User-Interface Card, “XPDU”=User-Interface Card with On-Screen Display, “XPXT”=regular Transmit
Card, “XPXR”=regular Receive Card, “XPST”=CAT5 Transmit Card, “XPSR”=CAT5 Receive Card, “XPIQ” = Management
Card, and “XPSI” = Serial Control Card.

3. The “HW Rev” column lists the revision level of the component’s hardware.

4. The “EPROM FW Rev” column lists the revision level of the component’s original firmware (that is, the firmware burned into

its EPROMs at the factory).

5. The “FLASH FW Rev” column lists the revision level of the most recent firmware (if any) that has been downloaded to the

component’s Flash ROMs.

6. The “Serial #” column lists the component’s serial number. Unless the component is an eval, demo, or special unit, the serial

number should always be numeric.

7. The “Other Information” column shows the Switch’s best guess of what the component is attached to (if anything) based on

the states of the ground leads of the component’s connector(s).

8. What “* - Indicates active device” means is that the asterisk shows whether the component is running using the firmware in

its EPROMs or the firmware in its Flash ROMs.