GenTran 5.1 Manual De Usuario

Gentran:Server for Windows User’s Guide

Gentran:Server for Windows – November 2005

Using Interchanges

Resending Interchanges

7 - 19

To resend a specific outbound interchange, complete the following steps: 

The following describes the system process that occurs when you resend an 
interchange: 

1

From the appropriate area of The Desk, select Interchanges.

System response
The system displays the Interchanges Browser.

2

Select the outbound interchange that needs to be resent.

3

From the Document menu, select Resend.

System response
The system displays the Gentran:Server for Windows dialog box.

4

Click Yes to start the transmission session.

1

When the resend command is executed, the system first determines if 
it is a TRADACOMS interchange. If the interchange is 
TRADACOMS, the system increments the current version number in 
the FIL segment by one. After this update, the interchange is resent in 
the same manner as all other interchanges.

2

Communication is established with the remote end. The status of the 
message is updated based on the success or failure of the 
communications session.

◗

If communication fails because there is no mailbox set up or the 
Mailbox service is not started, the interchange and documents are 
left in a Ready to send status.

◗

If communication fails because there is no modem, the 
interchange and documents are left in a Queued status. 

Note
No user action is required at this point. Interchanges that failed to 
send are automatically sent as part of the next transmission session.

3

The documents are moved to the Out Drawer Browser and the 
interchange status is set to Sent.