Graco 258864 Manual De Usuario
Install Tip/Guard Assembly (if not installed)
3A0705E
11
Install Tip/Guard Assembly
(if not installed)
(if not installed)
Reversible Tip Selection Chart
1.
Engage trigger lock and put prime/relief valve UP to
release pressure. Then remove Tip/Guard Assembly.
release pressure. Then remove Tip/Guard Assembly.
2.
Install filter to Spray Tip/Guard Assembly (make sure
filter is fully installed into sprayer). NOTE: Filter assem-
bly is reverse-threaded. Turn left (or counter-clock-
wise) to install. Turn right (or clockwise) to remove.
filter is fully installed into sprayer). NOTE: Filter assem-
bly is reverse-threaded. Turn left (or counter-clock-
wise) to install. Turn right (or clockwise) to remove.
3.
Firmly screw Tip/Guard Assembly onto sprayer.
Tighten retaining nut until completely engaged with
sprayer. If Tip/Guard Assembly is not fully tightened,
poor spray results and possible damage to the sprayer
could occur.
Tighten retaining nut until completely engaged with
sprayer. If Tip/Guard Assembly is not fully tightened,
poor spray results and possible damage to the sprayer
could occur.
MATERIALS
*Thin
Medium
Heavy
Thin stains,
semi-transparent stains
Enamels, solid
stains, thin latex
Heavy latex
311
315, 515
517
*Install Fine-Finish Optimizer, see page 8.
ti14999a
ti14994a
NOTICE
Make sure filter is completely screwed into the Tip/Guard
Assembly to avoid splattering material or damage to the
filter.
Assembly to avoid splattering material or damage to the
filter.
NOTICE
The tip is a permanently attached to the guard.
Removing the tip from the guard will result in damage
to tip assembly.
Removing the tip from the guard will result in damage
to tip assembly.
ti14775a
ti15490a