Graco ti13585a Manual De Usuario
Installation
12
313516G
Mount Gun
Reciprocating Arm Rod Mount
To mount the gun on a reciprocating arm rod
[0.5 in. (13 mm) diameter maximum]:
[0.5 in. (13 mm) diameter maximum]:
1. Insert the mounting bar (A) through the
hole in the manifold as shown in F
NOTE: Use the 1/8 in. alignment pin (P) to
assist in orienting the gun.
assist in orienting the gun.
2. Secure the gun to the bar by tightening the
mounting screw (B).
Stationary Support
To mount the gun on a stationary support
(refer to F
(refer to F
. 4 and to the correct mounting
1. Align the manifold with the alignment pins.
Locate alignment pins and holes per the
mounting hole layout.
mounting hole layout.
2. Secure the gun to the support with two M5
x 0.8 capscrews (C). The screws must be
long enough to engage the threaded holes
in the gun manifold to a depth of 1/4 in.
(6 mm).
long enough to engage the threaded holes
in the gun manifold to a depth of 1/4 in.
(6 mm).
F
IG
. 3: Reciprocating Arm Mount
B
P
A
ti13587a
F
IG
. 4: Stationary Support Mount
C
ti13588a