Wagner SprayTech 7000 Manual De Usuario

2

3

1

4

r epa Irs  at  the  un It

Before mounting the new diaphragm, clean the insert as well 

as the grooved surface at the pressure insert (2) and the paint 

section (3) and wipe off any oil.

1.  First tighten all the hexagonal bolts (1) crosswise with 

30Nm, then crosswise with 70Nm.

2.  Before starting up leave the pressure control valve in the 

open position for about 2 minutes while the motor is run-

ning (bleeds the unit). Only then close it until the noise of 

the inlet valve can be heard.

These may only be carried out by a skilled 

electrician. No liability is assumed for incor-

rect installation.

Switch the unit off.

Before all repair work: Unplug the power 

plug from the outlet.

Despite the use of high-quality materials the highly abrasive 

effect of the paints means that wear can occur at the follow-

ing parts:

Inlet valve (spare part Order No.: 0254 524)

For replacing refer to Section 10.2

(failure becomes noticeable through  performance loss and/or 

poor or no suction)

Outlet valve (spare part Order No.: 0341702)

For replacing refer to Section 10.3

(failure becomes noticeable through performance loss and/

or poor suction) The outlet valve is usually considerably more 

durable than the inlet valve. Thorough cleaning may already 

help here.

Relief valve  (spare part Order No.: 0169248)

For replacing refer to Section 10.5

(failure is noticeable through performance loss. Furthermore 

material arrives constantly at the return hose although the 

multifunction switch is set to spraying.

This part is relatively seldom a wear part.

1.  Dismount the cover (1) by loosening the 6 recessed-head 

screws (4).

2.  Loosen the cable threaded joint (2).

3.  Loosen the wires in the mains terminal (3) .

4.  Replace the unit connecting line.

 

(only an approved power cable with the designation H07-

RNF with a splash-proof plug may be used).

5.  Connect the green/yellow wire to the contact with the PE 

sign.

6.  Connect the cover again and mount it carefully (do not 

squeeze any cables!)