Bunn MCP Manual De Usuario

TROUBLESHOOTING

SITUATION

EXPLANATION

Nothing happens when
the COFFEE BUTTON or
TEA BUTTON is pressed.

This is the ﬁrst time you have used your
brewer.

The Initial Brewer Set-up procedure must
be performed ﬁrst. Please follow the
directions on page 9 before attempting
to run a brew cycle.

Your brewer is not plugged in.

Check to make sure the brewer is
plugged in and the POWER SWITCH
has been turned on. (The POD HOLDER
RELEASE BUTTON - also known as the
BUNN Indicator - will be illuminating
red, indicating power to the brewer.)

The HEATING INDICATOR is lit.

Wait until the indicator goes off before
pressing one of the brew buttons. The
brewer will not start a brew cycle until
the water in the internal tank is heated to
the proper temperature.

The POD HOLDER INDICATOR is lit.

Check to make sure the POD HOLDER is
inserted into the brewer.
If the POD HOLDER is inserted into the
brewer, carefully remove and replace
the POD HOLDER to ensure the POD
HOLDER is locked in place.
Listen for a clicking sound. The click
indicates that the holder has locked into
place.

The REFILL WATER INDICATOR is lit.

The reservoir has run low on water and
needs to be ﬁlled above the minimum
mark indicated on the side of the
reservoir.