Maytag W10359302A Hoja De Datos

If your model came with a Reversibility kit or you purchased a kit 
for your contour door refrigerator, please use the Brand Badge 
Placement template and the following instructions to install the 
Brand Badge on the opposite side of the freezer door. 

Brand badge removal tool

Brand badge template (on last page of User Instructions)

Hole cover decal (color coordinated to exterior) 

Scissors

Masking tape

1. Using the removal tool (provided), remove the brand badge 

from the freezer door by lifting up the right-hand side and 
peeling the badge away from the door from right to left.

NOTE: To avoid scratching the door, do not use a sharp or 
metallic object to pry the brand badge from the door. 

2. Rub a small amount of liquid dish soap over any adhesive 

residue with your fingers. Rinse the door with warm water and 
dry with a soft cloth.

3. Cut the template along the dotted lines that match the shape 

of the brand badge.

4. Align the edges of the template with the side and top of the 

freezer door and tape the template to the door. 

NOTE: When the template is correctly aligned, the hole in the 
door, where the handle was, will be within the cutout of the 
template, as shown.

5. Using the cutout as a guide, press the brand badge onto the 

freezer door making sure that the hole is completely covered. 

6. Slowly remove the template.

IMPORTANT: To comply with American Disabilities Act (ADA) 
guidelines, fully retract the rollers into the cabinet to lower the 
refrigerator. 

Your refrigerator has two front adjustable rollers – one on the right 
and one on the left. If your refrigerator seems unsteady or you 
want the doors to close easier, adjust the refrigerator's tilt using 
the following instructions: 

1. Remove the base grille. See the Base Grille graphic in 

“Refrigerator Doors.” The two leveling screws are part of the 
front roller assemblies, which are at the base of the 
refrigerator on either side.

2. Use a socket driver to adjust the leveling screws. Turn the 

leveling screw to the right to raise that side of the refrigerator 
or turn the leveling screw to the left to lower that side. It may 
take several turns of the leveling screws to adjust the tilt of 
the refrigerator. 

NOTE: Having someone push against the top of the 
refrigerator takes some weight off the leveling screws and 
rollers which makes it easier to adjust.

3. Open both doors again to make sure they close as easily as 

you like and that they stay closed. If not, tilt the refrigerator 
slightly more to the rear by turning both leveling screws to the 
right. It may take several more turns.

NOTES: 

■

To keep the refrigerator level, you should turn both 
leveling screws the same amount.

■

On models with the leveling/roller assembly, after 
adjusting the refrigerator to the desired tilt, turn the 
leveling leg until it is firmly against the floor as shown.

4. Replace the base grille.

A

B

C