Maytag W10359302A Hoja De Datos

If the space between your doors looks uneven, you can adjust it 
using the following instructions:

1. Pry off the top hinge cover.

2. Loosen the top hinge screws using a 

⁵⁄₁₆" socket or wrench.

3. Have someone hold the door in place or put a spacer 

between the doors while you tighten the top hinge screws.

4. Replace the top hinge cover.

On some models, your refrigerator's accessory packet includes 
an air filter, which must be installed prior to use. On some 
models, the air filter is already installed at the factory. 

The air filter reduces the buildup of odors. This helps to maintain 
a cleaner environment inside the refrigerator. 

The filter should be installed behind the vented door, which is 
located (depending on your model) along either the rear or left 
interior wall near the top of the refrigerator compartment.

1. Remove the air filter from its packaging.

2. Lift open the vented door.

3. Snap the filter into place.

The filter comes with a status indicator, which should be 
activated and installed at the same time the air filter is installed. 

1. Place the indicator face-down on a firm, flat surface.

2. Apply pressure to the bubble on the back of the indicator, 

until the bubble pops to activate the indicator.

3. Lift open the vented air filter door. On some models, there are 

notches behind the door.

■

Slide the indicator down into the notches, facing outward.

NOTE: The indicator will not easily slide into the notches 
if the rear bubble has not been popped.

■

Close the air filter door, and check that the indicator is 
visible through the rectangular hole in the door.

■

Store the indicator in a visible place you will easily 
remember - either inside the refrigerator, or elsewhere in 
your kitchen or home.

The control panel displays the Air Filter status. 

■

GOOD - The air filter LED does not light up. 

■

REPLACE - The air filter LED lights up constantly when the 
refrigerator door is open. 

■

EXPIRED - The air filter LED lights up constantly and flashes 
when the refrigerator door is open. 

After replacing the air filter, press and hold FILTERS RESET for 
3 seconds. The filter icons will turn off. See “Using the 
Control(s).”

NOTE: At any filter status, pressing and holding FILTERS RESET 
for 3 seconds will reset the air filter status to good and the air 
filter LED will turn off.

The disposable air filter should be replaced every 6 months, or 
when the status indicator air filter icon LED turns on and starts 
flashing when the refrigerator door is opened. 

To order a replacement air filter, contact us using the 
assistance/service information following the warranty. 

1. Remove the old air filter by squeezing in on the side tabs.

2. Remove the old status indicator.

3. Install the new air filter and reset the status indicator using 

the instructions in the previous sections.

The accessory packet includes two produce preserver pouches, 
which should be installed in a crisper drawer prior to use.

NOTE: For best performance, always use two pouches. 

The produce preserver absorbs ethylene, to slow the ripening 
process of many produce items. As a result, certain produce 
items will stay fresh longer.

Ethylene production and sensitivity varies depending on the type 
of fruit or vegetable. To preserve freshness, it is best to separate 
produce with sensitivity to ethylene from fruits that produce 
moderate to high amounts of ethylene. 

Very 

Low

Low

High

Very

High

High

Broccoli

Lettuce

Spinach

Apples

Pears

Med.

Asparagus

Citrus fruit

Cantaloupe

Low

Carrots

Grapes

Berries