Maytag W10359302A Hoja De Datos

The water filter status light will help you know when to change 
your water filter. 

■

When it is time to order a replacement water filter, the water 
filter icon LED will light up whenever the refrigerator door is 
open. 

■

When it is time to replace the water filter, the water filter icon 
LED will light up and flash whenever the refrigerator door is 
open. 

The disposable water filter should be replaced at least every 
6 months, or sooner depending on your water quality and usage.

■

After changing the water filter, reset the status. Press and 
hold the FILTERS RESET button for 3 seconds. When the 
system is reset, the water filter icon LED will turn off.

1. Locate the water filter in the top-right corner of the 

refrigerator compartment.

2. Lift open the filter cover door. The filter will be released and 

then be ejected as the door is opened.

3. When the door is completely open, pull the filter straight out.

NOTE: There may be some water in the filter. Some spilling 
may occur. Use a towel to wipe up any spills.

4. Take the new filter out of its packaging and remove the 

covers from the O-rings. Be sure the O-rings are still in place 
after the covers are removed.

5. With the arrow pointing up, align the new filter with the filter 

housing and slide it into place. The filter cover door will 
automatically begin to close as the new filter is inserted.

6. Close the filter cover door completely in order to snap the 

filter into place. You may need to press hard.

7. Make and discard three full containers of ice to prepare the 

water filter for use, before using the ice.

Both the refrigerator and freezer sections defrost automatically. 
However, clean both sections about once a month to avoid 
buildup of odors. Wipe up spills immediately.

■

Because air circulates between both sections, any odors 
formed in one section will transfer to the other. You must 
thoroughly clean both sections to eliminate odors. To avoid 
odor transfer and drying out of food, wrap or cover foods 
tightly.

■

For stainless steel models, stainless steel is corrosion-
resistant and not corrosion-proof. To help avoid corrosion of 
your stainless steel, keep your surfaces clean by using the 
following cleaning instructions.

NOTE: Do not use abrasive or harsh cleaners such as window 
sprays, scouring cleansers, flammable fluids, muriatic acid, 
cleaning waxes, concentrated detergents, bleaches or cleansers 
containing petroleum products on exterior surfaces (doors and 
cabinet), plastic parts, interior and door liners or gaskets. Do not 
use paper towels, scouring pads, or other harsh cleaning tools.

1. Unplug refrigerator or disconnect power.

2. Hand wash, rinse, and dry removable parts and interior 

surfaces thoroughly. Use a clean sponge or soft cloth and a 
mild detergent in warm water. 

3. Clean the exterior surfaces.

Painted metal: Wash painted metal exteriors with a clean, 
soft cloth or sponge and a mild detergent in warm water. 
Rinse surfaces with clean, warm water and dry immediately 
to avoid water spots.

Stainless steel: Wash stainless steel surfaces with a clean, 
soft cloth or sponge and a mild detergent in warm water. 
Rinse surfaces with clean, warm water and dry immediately 
to avoid water spots. 

NOTE: When cleaning stainless steel, always wipe in the 
direction of the grain to avoid cross-grain scratching. 

Do not use with water that is microbiologically unsafe or 
of unknown quality without adequate disinfection before 
or after the system. Systems certified for cyst reduction 
may be used on disinfected waters that may contain 
filterable cysts.