Schneider Electric EM3555 Manual De Usuario

7

© 2011 Schneider Electric All Rights Reserved.

NOTE:  Observe correct CT orientation.

The meter can be mounted in two ways:  on standard 35 mm DIN rail or 

screw-mounted to the interior surface of the enclosure. 

A.  DIN Rail Mounting

1.  Disconnect and lock out power. Use a properly rated voltage sensing device 

to confirm power is off.

2.  Attach mounting clips to the underside of the housing by sliding them into 

the slots from the inside. The stopping pegs must face the housing, and the 

outside edge of the clip must be flush with the outside edge of the housing.

3.  Snap the clips onto the DIN rail. See diagram of the underside of the 

housing (Figure 3).

Clip flush 

with outside 

edge
Snap onto 

DIN rail

Insert clips from 

inside

4.  To prevent horizontal shifting across the DIN rail, use two end stop clips. 

B.  Screw Mounting

1.  Disconnect and lock out power. Use a properly rated voltage sensing device 

to confirm power is off.

2.  Attach the mounting clips to the underside of the housing by sliding them 

into the slots from the outside. The stopping pegs must face the housing, 

and the screw hole must be exposed on the outside of the housing.

3.  Use three #8 screws (not supplied) to mount the meter to the inside of the 

enclosure. See diagram of the underside of the housing (Figure 4).

Screw 

holes 

exposed 

for 

mounting

Insert clips from 

outside