Schneider Electric PM5100 Manual De Usuario

PowerLogic™  PM5100 series user guide 

Chapter 11—Meter resets

© 2014 Schneider Electric All Rights Reserved

77

Reset commands clear the meter’s onboard data logs and related registers. Meter 
resets are typically performed after you make changes to the meter’s basic setup 
parameters (such as power system, frequency, or PT/CT settings), to clear invalid or 
obsolete data in preparation for putting the meter into active service.

The meter reset commands are grouped into two categories: Global Resets and Single 
Resets.

To access the meter reset screens, navigate to Maint > Reset.

Global resets allow you to clear all data of a particular type, such as all energy values or 
all minimum/maximum values.

 is a special command that clears the meter’s recorded logged data, 

counters and timers. It is common practice to initialize the meter after its configuration is 
completed, before adding it to an energy management system.

1. Navigate to Maint > Reset.

2. Move the cursor to point to Global Reset, then press Select.

3. Move the cursor to point to the parameter you want to reset, then press Reset.

4. Enter the reset password (default is “0000”), then press OK.

5. Press Yes to confirm the reset or No to cancel and return to the previous screen.

Record all important data before performing meter resets.

Maint

Reset

Setup

Diag

Meter Initialization

Clears all data listed in this table (energy, demand, min/max values, 
counters, logs, timers, and input metering data).

Energies

Clears all accumulated energy values (kWh, kVARh, kVAh).

Demands

Clears all the demand registers.

Min/Max

Clears all the minimum and maximum registers.

Alarm Counts & Logs

Clears all the alarm counters and alarm logs.