Schneider Electric Altivar 12 Manual De Usuario

BBV28581  05/2010

29

Read carefully the safety information in the user manual and the catalogue. Before starting up the drive, please check the following points
regarding mechanical and electrical installations, then use and run the drive.
For complete documentation, refer to www.schneider-electric.com.

• For drive mounting types and recommendations on the ambient temperature, please refer to the Mounting and temperature conditions 

instructions on page 

• Mount the drive vertically as specified, see Mounting and temperature conditions instructions on page 

• The use of the drive must be in agreement with the environments defined by the standard 60721-3-3 and according to the levels 

defined in the catalogue.

• Mount the options required for your application, refer to the catalogue. 

• Connect the drive to the ground, see Equipment grounding on page 

• Ensure that the input power voltage corresponds to the drive nominal voltage and connect the line supply as shown in General wiring 

diagram on page 

.

• Ensure you use appropriate input power fuses and circuit breaker on page 

• Wire the control terminals as required, see Control terminals on page 

. Separate the power cable and the control cable according 

to the EMC compatibility rules on page 

.

• The ATV12ppppM2 range integrates an EMC filter. The leakage current can be reduced using the IT jumper as explained in the 

paragraph Internal EMC filter on ATV12ppppM2 on page 

• Ensure that motor connections correspond to the voltage (star, delta).

• Start the drive and you will see 

 at the first power on. Check that the frequency defined by 

the frequency 

bFr

 (the factory setting is 50 Hz) is in accordance with the frequency of the motor, see First power-up on page 

For the following power on, you will see 

rdY

 on the HMI.

• MyMenu (upper part of CONF mode) allows you to configure the drive for most applications (see page 

•

 function page 

 allows you to reset the drive with factory settings.